D-Link Forums
The Graveyard - Products No Longer Supported => Access Points / Extenders => DAP-1360 => Topic started by: davesemm on June 23, 2014, 12:38:42 AM
-
I tried both the default password (blank) and the password from before update. The repeater works, so the WiFi password wasn't reset and the unit is functioning. But I can't log into http://dlinkap to change the settings.
I updated the firmware because comms was unreliable with a new laptop; I hoped this would help.
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=48135.0)
- What region are you located?
- Was a Factory Reset performed before and after any firmware updates then set up from scratch?
FW Update Process (http://forums.dlink.com/index.php?topic=42457.0)
PC Web Browser Configurations
What browser are you using?
Try Opera or FF? If IE 8, 9, 10 or 11, set compatibility mode and test again.
Disable any security browser Add-ons like No Script and Ad-Block or configure them to allow All Pages when connected to the router.
Clear all browser caches.
Be sure to log into the Admin account on the router.
Try turning off these features in Chrome:
Top right corner, little bars for options > Settings > Settings (on left) > Show advanced settings.
Uncheck these:
Use a web service to help resolve navigation errors
Use a prediction service to help complete searches and URLs typed in the address bar
Predict network actions to improve page load performance
Enable phishing and malware protection
-
davesemm, reset the unit with the reset button. And start over. Will probably work then.
-
He hasn't been on since he posted this so I presume he got it fixed. We Hope!
::)
davesemm, reset the unit with the reset button. And start over. Will probably work then.
-
HAHA, oh, ok, did not see that.
Guess he fixed it then.
-
We hope. ::)