D-Link Forums
The Graveyard - Products No Longer Supported => Network and WIreless Adapters => DWA-160 => Topic started by: auwkeung on August 20, 2011, 09:47:13 PM
-
Hello
I am using an iMac with Lion installed and have followed your instructions to install my newly purchased DWA-160 (A2)
I downloaded the driver from D-Link website and it's version 4.0.0.10, at first it refused to install. Then I discovered this thread:
http://forums.dlink.com/index.php?topic=13684.0
I followed the instructions, the D-Link program installed successfully after editing the package content, but when I type the command in Terminal, it returns the following error:
Warnings:
Executable does not contain code for architecture:
x86_64
Can't load /System/Library/Extensions/AtherosOtusMac.kext - no code for running
Can someone please offer some help?? Please... :-[
-
I have the same problem, so i download the chip driver from this page: http://www.ralinktech.com.tw/en/04_support/license.php?sn=5004, is for Mac OSX lion but unfortunately for me don't work, the software is installed without any problems, but don't recognize the network card interface, please somebody help me, i don't know what to do, what next, return back mi network card to the store? ??? :(
-
If you boot up os x lion in 32 bit mode (hold down the 3 and 2 while it starts up, the drink software should load properly. d-link has to make their software 64 bit compatible
-
I installed the ralink drivers on 10.7.3 and it works well. You do have to reboot the Mac while holding down 3 and 2 keys on the Mac to get into 32bit mode. After the ralink drivers are installed then just reboot the Mac with out holding the keys down and boot normally into 64 bit mode. Good find.
-
has anyone had any success with mountain lion? i just jumped from snow leopard (10.6) to mountain lion (10.8) and the instructions for lion (10.7) doesn't seem to be working in this case. i can't even get the adapter to light up anymore. any help would be appreciated!
-
You get this going?
has anyone had any success with mountain lion? i just jumped from snow leopard (10.6) to mountain lion (10.8) and the instructions for lion (10.7) doesn't seem to be working in this case. i can't even get the adapter to light up anymore. any help would be appreciated!