D-Link Forums

The Graveyard - Products No Longer Supported => D-Link NetDefend Firewalls => Topic started by: RanmaKei on November 05, 2012, 06:22:24 PM

Title: Can you use HA with DMZ in transparent mode on a single port?
Post by: RanmaKei on November 05, 2012, 06:22:24 PM

Can you use HA with 'DMZ in transparent mode on a single port' while using NAT and vpn on another port?

Here is the setup I want to implement.

http://www.fuzeqna.com/sonicwallkb/consumer/kbdetail.asp?kbid=5979

I want to be able to VPN into the firewall either on the primary or the backup device in a HA Setup. Then be able to access the servers on the internal management network(10.51.10.1-10.51.10.254)[port X0]. On the DMZ [X2] I want to have transparent DMZ so that I have IPS protection for servers that will have their WAN NIC's set to a public IP address.

Title: Re: Can you use HA with DMZ in transparent mode on a single port?
Post by: danilovav on November 20, 2012, 01:11:01 PM

Transparent mode itself will works in this configuration.

But, i'm not sure about HA.

Title: Re: Can you use HA with DMZ in transparent mode on a single port?
Post by: chechito on December 01, 2012, 08:55:39 PM

from firmware release notes:

Known Issues:
Firmware
Version
Known Issues
2.40.01
...
3. Transparent Mode won’t in HA mode.