• March 28, 2024, 06:40:33 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: 0dbM WiFi Transmit Power  (Read 6608 times)

GlennXS

  • Level 1 Member
  • *
  • Posts: 1
0dbM WiFi Transmit Power
« on: May 18, 2021, 08:27:25 PM »

I have a DSR-500N that reports no/0 transmit power; however i setup the transmit power value.  The reason i'm concerned is because various client devices in close proximity cannot see any AP broadcast as configured on this DSR-500N; however i setup its profiles/APs.  -Is it fair to say that the radio of this DSR-500N is broke?  That is, is there a test configuration that i could implement that should work regardless/every time?
 
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49923
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: 0dbM WiFi Transmit Power
« Reply #1 on: May 19, 2021, 05:43:24 AM »

Link>Welcome!

  • What Hardware version is your router? Look at sticker under the router case.
  • Link>What Firmware version is currently loaded? Found on the routers web page under status.
  • What region are you located?

Even after a factory reset of the DSR?
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.