• January 20, 2022, 10:25:59 PM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search  

News:

This Forum Beta is ONLY for registered owners of D-Link products in the USA for which we have created boards at this time.

Author Topic: Auto-rollover not enabled DSR 1000N  (Read 3539 times)

vwiencek

  • Level 1 Member
  • *
  • Posts: 1
Auto-rollover not enabled DSR 1000N
« on: September 14, 2013, 01:00:31 AM »

Dear all,

I've bought a DSR 1000N.
I first internet connection is enabled and working on WAN 1
I have a USB 3G key plugged on USB (WAN 3)

I can manually switch between WAN 1 and 3 and it works, but I can not enable auto-rollover. The checkbox 'auto-rollover using WAN port' is disabled in DSR interface and I don't know how to enable it.

Could you please help me ?

Hardware version A1
DSR-1000N Firmware Version: 1.08B51_WW

Thank
Logged

FurryNutz

  • Poweruser
  •   ▲
    ▲ ▲
  • *****
  • Posts: 49884
  • D-Link Global Forum Moderator
    • Router Troubleshooting
Re: Auto-rollover not enabled DSR 1000N
« Reply #1 on: September 15, 2013, 11:03:11 AM »

Link>Welcome!
  • What region are you located?

Web Browser Configurations
What browser are you using?
Try Opera or FF? If IE 8 or 9, set compatibility mode and test again.
Try turning off these features in Chrome:
Top right corner, little bars for options > Settings > Settings (on left) > Show advanced settings.
Uncheck these:
Use a web service to help resolve navigation errors
Use a prediction service to help complete searches and URLs typed in the address bar
Predict network actions to improve page load performance
Enable phishing and malware protection

I recommend that you download and install the following for your model router:
DSR-500N_A1_FW1.08B51_WW

There could be some minor differences between the 1000N and 500N even though FW file could be the same.

If this fails even after the re-install of FW, you'll need to phone contact your regional D-Link support office and ask them about this feature and how to configure it.

Good Luck.
Logged
Cable: 1Gb/50Mb>NetGear CM1200>DIR-882>HP 24pt Gb Switch. COVR-1202/2202/3902,DIR-2660/80,3xDGL-4500s,DIR-LX1870,857,835,827,815,890L,880L,868L,836L,810L,685,657,3x655s,645,628,601,DNR-202L,DNS-345,DCS-933L,936L,960L and 8000LH.