The Graveyard - Products No Longer Supported > DIR-855L

Could dlink make a new firmware to add ipv6 pass-through ability for the router?

(1/1)

LynnField1366:
only in this way i can get the access to ipv6...

 :(

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
How do you have the router configured? There is a a drop down for Automatic and Local Only. I think if you use local only with out any other configurations, IPv6 should pass thru. Not sure however.

FYI:
    This product has been discontinued.
    Free support for this product will end on 05/01/2018

If you can't seem to get the 855 to work, you might try some DD-WRT or OpenWRT to see if they support this model router....

You can use this as as LAN to LAN AP then anything will pass-thru: Turning a router into an AP.

FurryNutz:
Any status on this?  ???


--- Quote from: LynnField1366 on March 07, 2017, 10:58:16 AM ---only in this way i can get the access to ipv6...

 :(

--- End quote ---

Navigation

[0] Message Index