D-Link VPN Router > DSR-1000AC

Wifi 2.4Ghz not able to see it

(1/1)

scoody:
Hi,

I installed without any trouble the DSR1000 FW 3.10_WW , but i only see the 5Ghz wifi 802.11n, the access point and profiles are also created in 2.4Ghz but i don't see them with my devices that are juste able to see the 2.4Ghz.

A few desktops are able to see the 5Ghz and it's working fine.

All is by default, i tried to change encrypt wep to wpa the WPA2 , tried to assigne some antennas but nothink works...

Regards

FurryNutz:
Link>Welcome!


* What Hardware version is your router? Look at sticker under the router case.
* Link>What Firmware version is currently loaded? Found on the routers web page under status.
* What region are you located?
Temporarily disable security on 2.4Ghz and see if any of the affected devices can see and connect to the 2.4Ghz radio. Then re-enable WPA and TPIK and see if devices can still connect. Then try WPA2 and AES only and test devices.

What channels are you using? 1, 6 or 11 is recommended for 2.4Ghz.
li]Any 2.4Ghz or 5Ghz cordless house phones or WiFi APs near by that maybe causing interferences?[/li]
[li]Any other WiFi routers in the area that maybe causing interferences? Link> Use a WiFi Scanner to find out. How many?[/li][/list]

scoody:
Hi,

Hardware A1
Firmaware it was written in my message : FW 3.10_WW
Region : France

Without security : Same trouble

Channels : in automatic

No neighbourg at all .

Best Regards

FurryNutz:
I recommend that you phone contact your regional D-Link support office and ask for help and information regarding this. We find that phone contact has better immediate results over using email.
Let us know how it goes please.

Navigation

[0] Message Index