D-Link Forums
The Graveyard - Products No Longer Supported => DIR-655 => Routers / COVR => Europe DIR-655 => Topic started by: bblaze on April 22, 2013, 07:13:05 AM
-
EIR655EEU...A2g wich firmware?
Currently installed firmware is 1.03EU
Wich is the correct one.
Because i can only select revision A1 or B1 from the D-link site.
The problem is that i have to reset the router three times a day.
Because he is dropping the internet connection, there is a connection with the router but no internet.
Maybe the firmware update helps.
With kind regards
BBlaze
-
Link>Welcome! (http://forums.dlink.com/index.php?topic=41537.0)
What region are you located?
You need to select Rev A for your Rev A model router.
Follow this for doing FW upgrades: FW Update Process (http://forums.dlink.com/index.php?topic=42457.0)
What ISP Service do you have? Cable or DSL?
What ISP Modem Mfr. and model # do you have?
Check ISP MTU requirements, Cable is usually 1500, DSL is around 1492 down to 1472. Call the ISP and ask. Link>Checking MTU Values (http://forums.dlink.com/index.php?topic=53008.0)
For DSL/PPPoE connectionds on the router, ensure that "Always ON" option is enabled.
Some things to try: - Log into the routers web page at 192.168.0.1. Use IE, Opera or FF to manage the router.
Turn off ALL QoS (http://vonage.nmhoy.net/qos.html) or Disable Traffic Shaping (DIR only) GameFuel (DGL only and if ON.) options. Advanced/QoS or Gamefuel.
Turn off Advanced DNS Services if you have this option under Setup/Internet/Manual or under Setup/PARENTAL CONTROL/Set to>None: Static IP or Obtain Automatically From ISP.
Enable Use Unicasting (compatibility for some ISP DHCP Servers) under Setup/Internet/Manual.
Turn on DNS Relay under Setup/Networking.
Setup DHCP reserved IP addresses for all devices ON the router. Setup/Networking. This ensures each devices gets its own IP address when turned on and connected, eliminates IP address conflicts and helps in troubleshooting.
Ensure devices are set to auto obtain an IP address.
If IPv6 is an option on the router, select Local Connection Only or Disable IPv6 options under Setup/IPv6.
Set Firewall settings to Endpoint Independent for TCP and UDP under Advanced/Firewall.
Enable uPnP and Multi-cast Streaming under Advanced/Networking. Disable uPnP for testing Port Forwarding rules. Enable IPv6 Multi-cast Streaming for routers that have a Media Server option. Disable IPv6 Multi-cast Streaming if IPv6 or Media Server is not being used.
Turn off WISH, and WPS under Advanced.
WAN Port Speed set to Auto or specific speed? Some newer ISP modems support 1000Mb so manually setting to Gb speeds can be supported by the router. Advanced/Advanced Networking/WAN Port Speed
Set current Time Zone, Date and Time. Use an NTP server feature. Tools/Time.
-
-I live in the Netherlands.
-I have Cable
-Cable modem is Ziggo Ubee EVW3200
-
You'll need this FW for updating:
http://www.dlink.com/nl/nl/support/product/dir-655-wireless-n-gigabit-router?revision=deu_reva (http://www.dlink.com/nl/nl/support/product/dir-655-wireless-n-gigabit-router?revision=deu_reva)